Made with ScholarlyTurn your own notes into slides like these
Shared with you
The document sets the source state for an orbital thermal qualification process to HOLD. The controlling reason is that H-01 drift is +0.011, exceeding the permitted limit of ≤ +0.010, so H-01 remains FAIL (p. 1). The source does not authorize deployment or approval and does not establish causation (pp. 1, 6–8).
HOLD is described as “the only supported decision until H-01 resolves” (p. 1). Release remains blocked until the failed gate is explicitly cleared; passing the other numeric gates does not change this decision (pp. 4, 7).
H-01 fails because its observed drift, +0.011, exceeds its limit of ≤ +0.010. Its disposition is therefore FAIL (p. 3). The source repeatedly preserves this exact status: H-01 = FAIL (p. 7).
The remaining numeric gates pass: pressure is 12.30 kPa against a limit of 12.00–12.50, and angle is −0.004° against a limit of ±0.005° (pp. 3–4). However, the document states that one failed gate is sufficient to keep the overall decision at HOLD (p. 4).
The sequence is explicitly “a control requirement, not a deployment signal” (p. 6). The symbols and order must be preserved as 🟢 → 🟡 → 🔴; this order does not authorize deployment (pp. 2, 6).
The process must follow these four actions in order (p. 2):
The source specifically warns not to reverse COLLECT 09:00 and COMPARE 12:30 (p. 2).
The gate table evaluates three measured conditions and raster order (p. 3):
The conclusion is still HOLD because no source authorizes deployment (p. 3).
The exact measured series is (p. 5):
0.000,+0.011,−0.004,+0.003,0.000The series must retain its zeros, negative value, signs, order, and trailing zeros. The plotted series shows the values in the same T0–T4 order (p. 5).
No calculation formula is provided. The key quantitative comparison is the gate check: +0.011 > +0.010, so the observed H-01 drift does not satisfy the stated condition ≤ +0.010 and remains FAIL (pp. 1, 3, 8).
Be able to:
Current state: HOLD. H-01 remains FAIL at +0.011 versus ≤ +0.010. The required next action is to resolve H-01, verify raster order, obtain reviewer approval, and then reassess the decision. The final state explicitly asserts that no deployment or approval is supported (p. 8).
Make from this