q1 spec
Clone
Register
q1 spec
Flashcard Deck
Study
Untitled Flashcards
Study
In this filter, any signals having frequency in-between cutoff frequencies are rejected.
Band-stop filter
This type of embedded system is categorized according to scale.
[based on performance?]
In this transducer selection factor, transducer shall maintain the expected input and output relationship as described by the transfer function to avoid errors.
errors
In this type of filter, any signal with a frequency lower than the cutoff frequency gets blocked.
High-pass filter
This is used to overcome the non linearity in the displacement sensor.
capacitive
This converts the sensor output to suitable electrical form.
transduction element
In this transducer, the measurand is converted into a change in electrostatic charge or voltage generated by crystals when it is mechanically stressed.
piezoelectric induction
This material is used for room temperature applications.
[no answer yet]
This is related failure and success measurement and it is normally associated with calibration.
repeatability
This type of strain gauge has wire stretched that can be made of nickle,
unbonded strain gauge
The experimental determination of the transfer function of actuator.
calibration
This represents the slope of the transfer function.
[no answer yet]
Which among the choices is not one of the transducers selection factors?Sensitivity, Cross Sensitivity, Reliability, Accuracy
Reliability
This is the deviation of sensor's output at any given point.
hysteresis
This is a functional computer system on a chip device that contains processor, memory, and programmable I/O devices.
microcontroller
This system is related to a network to access the resources.
network embedded system
The movement of the sensor element is used to cause a change in electrical voltage, resistance, capacitance, or mutual inductance.
contact sensors
In this transducer selection factor, transducer shall not break down and maintain its input and output relationship under specified environmental condition.
environmental compatibility
This is used as an additional processing unit for running the application in place of using embedded device.
ASSP (Application Specific System Processor)
This transducer converts the mechanical elongation and compression into resistance change.
Strain gauge
This is the extent to which the measured value might be wrong and normally expressed in percentage.
accuracy
This is the drop rate of gain of the filter.
roll-off rate
This is related failure and success measurement and it is normally associated with calibration.
repeatability
This is used to convert desired parameter into electrically measurable signal
sensor system
In this transducer, the measurand is converted into a change in electrostatic charge or voltage generated by crystals when it is mechanically stressed.
piezoelectric induction
This indicate the range of the stimulus in which the device is usable.
frequency response
In a passive filter, this has no gain. While in active filter, this may have gain depending on the configuration of the circuit.
passband
This converts the sensor output to suitable electrical form
transduction element
These frequencies are defined by the cutoff frequency of the filter.
passband and stopband frequencies